8
Table Of Contents
- Logic Pro 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Pro
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- EuCon Support of Euphonix MC and System 5-MC
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Chapter 5 EuCon Support of Euphonix MC and System 5-MC 121
You can also use the Select key to switch between automation modes in Logic Pro:
 When you set the automation mode to Off or Read, the Select key switches between
these two modes.
 When you set the automation mode to Read or Touch, the Select key switches
between these modes.
To choose an automation mode on a CM408T channel strip:
1 Press the Wave and Y keys simultaneously.
The available automation modes are displayed in a pop-up menu on the CM408T
display.
2 Use the fader of the channel strip to scroll through the following:
 Isolate: Automation mode is Off.
 Read: Activates Read mode in Logic Pro.
 Write: Activates Write mode in Logic Pro.
 Read/Write: Activates Touch mode in Logic Pro.
3 Use the Y key to confirm your selection, or the N key to cancel the operation.
Note: If a write automation mode (Touch, Latch, Write) is active (and an automation
parameter is enabled in the Logic Pro > Preferences > Automation > Touch/Latch/Write
Erase settings), the red W LED is lit. The green LED is lit when a read automation mode
is active. Both LEDs are lit when Touch or Latch mode are active.
Using Knobsets
When using the Euphonix MC with Logic Pro, a knobset contains pages—each
comprised of eight parameters. Knobsets are organized hierarchically.
The top level knobset leads to the following knobsets:
 Inserts: Pressing the Inserts Soft Key switches to a list of all currently inserted plug-ins
(see the following section for details). The On key is lit if a plug-in is enabled (not
bypassed)—and does not belong to the dynamic, EQ, or filter plug-in groups (this
also applies to Audio Unit plug-ins). Pressing the On key switches the bypass state of
all plug-ins that do not fall into the dynamic, EQ, or filter groups.
 Input: Pressing the Input Soft Key switches to input parameters (see “Input Knobset”
on page 123).
 Dyn: The Dyn Soft Key is not currently used to display a list, or allow editing, of
dynamic plug-ins. The On key is lit when any Dynamic plug-ins are enabled (not
bypassed). Please note that this only applies to Logic Pro plug-ins, not Audio Unit
plug-ins. Pressing the On key switches the bypass state of all Dynamic plug-ins.