8

5
117
5 EuCon Support of Euphonix MC
and System 5-MC
Logic Pro supports the Euphonix EuCon protocol, enabling
enhanced communication between the MC or System 5-MC
and Logic Pro.
The following chapter describes how the MC and System 5-MC are used to control
Logic Pro in EuCon mode.
Note: This is an addendum to the MC operation manual and is limited to descriptions
of Logic Pro specific features. Please refer to the device operating manuals for more
information about your control surfaces.
Setting Up Your MC or System 5-MC
Please follow the steps outlined below to use your MC or System 5-MC with Logic Pro.
To set up the MC or System 5-MC for use with Logic Pro:
1 Set up your MC and/or CM408T units as described in the MC operation manual.
2 Install the EuConWS software (version 1.1.2 o r l a t er) on your Macintosh.
3 Ensure that your Macintosh computer is set up as a workstation on the MC (see MC
operation manual).
4 Assuming that the MC software is running on the MC: Select the Euphonix Menu icon
on the MC Touchscreen. Choose the Prefs menu item, then go to the About tab.
Ensure that EuCon version is 1.1.2 or l ater. If it isn’t, yo u’ll need to update the EuCon
software. Go to the Euphonix website for more information.