10.6

71Logic Pro Instruments
Select and edit the values of one or more zones
1. In Logic Pro, select the zone by doing one of the following:
• Click a rectangle in the keymap editor.
• Choose the zone name from the pop-up menu in the zone section of the inspector.
• Command-click a region containing overlapping zones, then drag horizontally to
cycle through each zone.
2. Hold down Shift, then click multiple zones in the keymap editor to select them.
All selected zones are highlighted with a white border, and Multiple is shown in the
inspector zone name field.
3. Drag the left, right, top, or bottom edge of the zone. When multiple zones are selected,
drag the edge of one selected zone to apply the same relative change to all other
selected zones.
Delete one or more zones
1. In Logic Pro, select the zone by doing one of the following:
• Click a rectangle in the keymap editor.
• Choose the zone name from the pop-up menu in the zone section of the inspector.
2. Hold down Shift, then click multiple zones in the keymap editor to select them.
All selected zones are highlighted with a white border, and Multiple is shown in the
inspector zone name field.
3. Press the Delete key.
The zone or zones are deleted. All associated sample, additive, or spectral data is
removed from the source.
Audition a zone
Enable the > icon below the keymap editor to hear a preview whenever a zone is clicked.
The sample is previewed, inclusive of loop settings but ignoring zone parameters such as
Tune, Volume, and Panning.
1. In Logic Pro, select the zone by doing one of the following:
• Click a rectangle in the keymap editor.
• Choose the zone name from the pop-up menu in the zone section of the inspector.
2. Click a key on the keyboard display below the zones.
• Click near the top of a key to audition low velocities.
• Click near the bottom of a key to audition high velocities.
Audio is sent directly to the Alchemy outputs, bypassing any filters or effects that
are enabled in other sections.