10.6

601Logic Pro Instruments
Reset all velocity and gate values to default settings
• In Logic Pro, the Reset button is shown at the left of the velocity/gate row. Click to reset
all velocity and gate values.
The default velocity setting is 75 percent. The default gate value is all four sections
active.
Use the Ultrabeat velocity/gate shortcut menu
• In Logic Pro, Control-click any step in the velocity/gate row to open a shortcut menu
that has the following commands:
• Alter Vel(ocities): Changes the velocity values of all steps by a random amount,
while retaining the selected beats (the Trigger row remains unchanged).
• Alter Gate (Time): Changes the note lengths of all steps by a random amount, while
retaining the selected beats (the Trigger row remains unchanged).
• Randomize Vel(ocities): Creates a new, random velocity value.
• Randomize Gate (Time): Creates a new, random gate value.
Set step accents in Logic Pro Ultrabeat
The Accent setting can be switched on or off for each drum sound. This enables you to
turn accents on for cymbals but turn accents off for the kick drum, for example.
Turn on accents and set the accent level
1. In Logic Pro, click the blue LED to the right of the Accent slider to turn on the accent
function.
2. Drag the Accent slider to globally set the volume of programmed accents.
Program an accent for a particular step
• In Logic Pro, click the blue LED above the step (steps 1 and 3 in the figure).
The sound at this step position is accentuated (played louder).