10.6

478Logic Pro Instruments
Sculpture delay effect parameters
Logic Pro Sculpture delay effect overview
This is a (project) tempo-syncable stereo or true surround delay. It can also run freely
(unsynchronized). The Delay section features all the general delay parameters you’d expect
from a delay plus the Groove (delay timing) Pad.
Sculpture Delay effect parameters
• Delay On/Off button: Turn the Delay effect on or off.
• Wet Level knob: Set the Delay output level.
• Feedback knob: Set the amount of delay signal that is routed back from the delay unit
output channels to the delay unit input channels. Negative values result in phase-
inverted feedback.
• Xfeed knob: Set the amount of delay signal that is fed from the delay unit left output
channel to the right input channel, and vice versa. Negative values result in phase-
inverted feedback of the crossfed signal.
In surround instances, the Xfeed knob controls crossfeedback between the delay
lines, but offers additional crossfeed modes. You can access these in the Extended
Parameters area.
• LoCut slider: Determine the cutoff frequency of the highpass filter at the delay line
output/feedback loop.
• HiCut slider: Determine the cutoff frequency of the lowpass filter at the delay line
output/feedback loop.
• Groove Pad: Graphically adjust delay times in stereo or surround instances. See
Sculpture Groove Pad (stereo) and Sculpture Groove Pad (surround).
• Input Balance slider: Move the stereo center of the Delay input to the left or right,
without the loss of any signal components. This makes it ideal for ping-pong delays.
In surround instances, this parameter moves all channels toward the front left or front
right channel.