10.6

331Logic Pro Instruments
• Start Key pop-up menu: Assign the key (note) for the first slice.
• Start Key Mapping pop-up menu: Choose Chromatic, White, or Black to map slices to
keys above the Start key.
• Gate button: Turn on to enable the release phase of Pitch, Filter, and Amp envelopes
when the key is released. Turn off to play the sample in One Shot mode.
• Play to End button: Turn on to play the triggered slice to the end marker position.
• Flex On/Off button: Turn Flex mode on or off. If Flex mode is turned on, an audio sample
is played at its original speed for all note pitches. See Use Flex in Logic Pro Quick
Sampler.
• Follow Tempo button: When Flex mode is active, turn on to follow the project tempo.
• (Flex) Speed pop-up menu:When Flex mode is active, choose a playback speed division
or multiplication value.
Tip: Flex Speed is also available as a modulation target.
Create and edit slices
In Logic Pro, while in Slice mode, you can do the following:
• Insert a slice marker by moving your pointer over the waveform display and clicking. The
vertical line at the pointer position indicates the insert position. Control-click to open
a shortcut menu, and choose Create Slice Marker to place a slice marker at the current
playback position.
• Reposition a slice marker by horizontally dragging the slice marker or its handle.
• Double-click a slice marker (not the slice marker handle) to delete it.
• Control-click a slice marker or its handle to open a shortcut menu, then choose Delete
Slice Marker or use another command.
• Click a slice marker handle to permanently display slice parameter values below the
waveform display. Click the “X” icon at the left of the parameter display bar to close it.
Note: This is the only way to view the Fade in and Fade Out parameters in Slice mode.
• Move your pointer to the bottom of each slice marker to show a Play icon. Press this to
play the slice.