X

Chapter 4 Dynamics processors 97
Use Multipressor
In the graphic display, the blue bars show the gain change—not merely the gain reduction—as
with a standard compressor. The gain change display is a composite value consisting of the
compression reduction, plus the expander reduction, plus the auto gain compensation, plus the
gain make-up.
Compression parameters
The Compression Threshold and Compression Ratio parameters are the key parameters for
controlling compression. Usually the most useful combinations of these two settings are a low
Compression Threshold with a low Compression Ratio, or a high Compression Threshold with a
high Compression Ratio.
Downward Expansion parameters
The Expansion Threshold, Expansion Ratio, and Expansion Reduction parameters are the key
parameters for controlling downward expansion. They determine the strength of the expansion
applied to the chosen range.
Peak/RMS and Envelope parameters
Adjusting the parameter between Peak (0 ms, minimum value) and RMS (root mean square
−200 ms, maximum value) is dependent on the type of signal you want to compress. An
extremely short Peak detection setting is suitable for compression of short and high peaks of low
power, which do not typically occur in music. The RMS detection method measures the power
of the audio material over time and thus works much more musically. This is because human
hearing is more responsive to the overall power of the signal than to single peaks. As a basic
setting for most applications, the centered position is recommended.
Output parameters
The Out slider sets the overall output level. Set Lookahead to higher values when the Peak/RMS
elds are set to higher values (farther towards RMS). Set Auto Gain to On to reference the overall
processing to 0 dB, making the output louder.