X

Chapter 4 Dynamics processors 96
•
Attack elds: Drag to set the time before compression starts for the selected band, after the
signal exceeds the threshold.
•
Release elds: Drag to set the time before compression stops on the selected band, after the
signal falls below the threshold.
•
Band on/o buttons: Turn each band on or o. When enabled, the button is highlighted, and
the corresponding band appears in the graphic display area above.
•
Byp(ass) buttons: Turn on to bypass the selected frequency band.
•
Solo buttons: Turn on to hear compression on only the selected frequency band.
•
Level meters: The bar on the left shows the input level, and the bar on the right shows the
output level.
•
Threshold arrows: Two arrows appear to the left of each Level meter.
•
Click the upper arrow to adjust the Compression Threshold (Compr Thresh).
•
Click the lower arrow to adjust the Expansion Threshold (Expnd Thresh).
Multipressor Output parameters
Multipressor’s parameters are grouped into three main areas: the graphic display in the upper
section, the set of controls for each frequency band in the lower section, and the output
parameters on the right.
Frequency band section
Graphic display section
Output section
Output parameters
•
Auto Gain button: Turn on to reference the overall processing of the signal to 0 dB, making the
output louder.
•
Lookahead value eld: Drag to set how far ahead the eect analyzes the incoming signal,
allowing faster reactions to peak volumes.
•
Out slider: Drag to set the overall gain at Multipressor’s output.
•
Level meter: Shows the overall output level.