X

Chapter 2 Delay eects 64
Align the values of several taps
1 Command-click in the Tap display, and drag while holding down the Command key.
A line trails behind the pointer as you drag.
2 Click the appropriate position to mark the end point of the line.
The values of taps that fall between the start and end points are aligned along the line.
Reset the value of a tap
You can use Delay Designer’s Tap display or Tap parameter bar to reset tap parameters to their
default values.
m To reset a parameter to its default setting in the Tap display: Option-click a tap to reset the selected
parameter to its default setting.
If multiple taps are selected, Option-clicking any tap resets the chosen parameter to its default
value for all selected taps.
m To reset a parameter to its default setting in the Tap parameter bar: Option-click a parameter value
to reset it to the default setting.
If multiple taps are selected, Option-clicking a parameter of any tap resets all selected taps to the
default value for that parameter.