X
Table Of Contents
- Logic Pro X Effects
- Contents
- Chapter 1: Amps and pedals
- Chapter 2: Delay effects
- Chapter 3: Distortion effects
- Chapter 4: Dynamics processors
- Chapter 5: Equalizers
- Chapter 6: Filter effects
- Filter effects overview
- AutoFilter
- EVOC 20 Filterbank
- EVOC 20 TrackOscillator
- EVOC 20 TrackOscillator overview
- Vocoder overview
- EVOC 20 TrackOscillator interface
- EVOC 20 TrackOscillator analysis in parameters
- Use EVOC 20 TrackOscillator analysis in
- EVOC 20 TrackOscillator U/V detection parameters
- EVOC 20 TrackOscillator synthesis in parameters
- EVOC 20 TrackOscillator oscillators
- EVOC 20 TrackOscillator formant filter
- EVOC 20 TrackOscillator modulation
- EVOC 20 TrackOscillator output parameters
- Fuzz-Wah
- Spectral Gate
- Chapter 7: Imaging processors
- Chapter 8: Metering tools
- Chapter 9: MIDI plug-ins
- Chapter 10: Modulation effects
- Chapter 11: Pitch effects
- Chapter 12: Reverb effects
- Chapter 13: Space Designer convolution reverb
- Chapter 14: Specialized effects and utilities
- Chapter 15: Utilities and tools
- Appendix: Legacy effects
Chapter 1 Amps and pedals 31
Pre-amp signal ow
The pre-amp section is very exible, and can be used in several ways when you use dierent
combinations of On/O and Pre/Post switches. The signal ow indicated in the Mode column is
in series when multiple processors are used—that is, the output of one processor signal is fed
into the next processor.
Mode EQ On/O Compressor On/
O
Additional EQ On/
O
Pre/Post switch
All o O O O
EQ only On O O
Compressor only O On O
Additional EQ only O O On
EQ into Compressor
only
On On O
EQ into Additional
EQ only
On O On
Additional EQ into
Compressor only
O On On Pre
Compressor into
Additional EQ only
O On On Post
All on (EQ into
Additional EQ into
Compressor)
On On On Pre
All on (EQ into
Compressor into
Additional EQ)
On On On Post