X

Appendix Legacy eects 283
Guitar Amp Pro eects
The eects parameters include Tremolo, Vibrato, and Reverb, which emulate the processors found
on many ampliers.
You can use the pop-up menu to choose either Tremolo, which modulates the amplitude or
volume of the sound, or Vibrato, which modulates the pitch.
Reverb can be added to either of these eects, or used independently.
To use or adjust an eect, you must rst enable it by clicking the corresponding On button to the
left. The On button is red when active.
Note: The Eects section is placed before the Presence and Master controls in the signal ow, and
receives the preamplied, pre-Master signal.
Tremolo and vibrato parameters
•
On/o button: Turns the tremolo/vibrato eect on or o.
•
FX pop-up menu: You can choose either Tremolo or Vibrato.
•
Depth knob: Sets the intensity of the modulation.
•
Speed knob: Sets the speed of the modulation in Hertz. Lower settings produce a smooth and
oating sound, while higher settings produce a rotor-like eect.
•
Sync button: When the Sync button is turned on, the modulation speed is synchronized to the
project tempo. You can adjust the Speed knob to select bar, beat, and musical note values
(including triplet and dotted notes). When the Sync button is turned o, the modulation speed
can be set to any available value with the Speed knob.
Reverb parameters
•
On/o button: Turns the reverb eect on or o.
•
Reverb pop-up menu: Choose one of the three types of spring reverb.
•
Level knob: Rotate to set the amount of reverb applied to the pre-amplied amp signal.