X

Chapter 13 Space Designer convolution reverb 258
Use the Space Designer Spread parameters
The Spread and Xover (crossover) knobs enhance the perceived width of the signal without
losing the directional information of the input signal normally found in the higher frequency
range. Low frequencies are spread to the sides, reducing the amount of low frequency content in
the center—allowing the reverb to encompass the mix.
Note: The Spread and Xover knobs function only in Synthesized IR mode.
m To set the level of the Spread knob and eld: Rotate to extend the stereo or surround base to
frequencies that fall below the frequency determined by the Xover parameter.
•
At a Spread value of 0.00, no stereo or surround information is added. (The inherent stereo or
surround information of the source signal and reverb, however, is retained.)
•
At a Spread value of 1.00, the left and right channel divergence is at its maximum.
m To set the level of the Xover knob and eld: Rotate to set the crossover frequency in Hertz. Any
synthesized impulse response frequency that falls below the value you set will be aected by the
Spread parameter (at values over 0).
Note: Because these parameters adjust stereo or surround processing, they have no impact
when you use Space Designer as a mono plug-in.