X

Chapter 13 Space Designer convolution reverb 252
Space Designer global parameters
Space Designer global parameters overview
Space Designer’s global parameters aect the overall output or behavior of the eect. See Use
Space Designer global parameters and Use Space Designer output parameters.
The global parameters are divided into two sections—those around the main display and those
below the main display.
Latency
Compensation button
Rev Vol
Compensation button
Output
sliders
Definition
area
Input
slider
Global parameters (upper)
•
Input slider: Move to determine how Space Designer processes a stereo or surround
input signal.
•
Latency Compensation button: Click to switch Space Designer’s internal latency compensation
feature on or o.
•
Denition elds: Drag to select a less-dened impulse response set, to emulate reverb diusion
and save CPU resources.
•
Rev(erb) Vol(ume) Compensation button: Click to turn on Space Designer’s internal impulse
response volume matching function.
•
Output sliders: Move to adjust output levels.
Global parameters (lower)
•
Pre-Dly knob and eld: Rotate to set the reverb’s predelay time, or time between the original
signal and the rst reections from the reverb.
•
IR Start knob and eld: Rotate to set the playback start point in the impulse response sample.
•
Spread and Xover knobs and elds: Rotate the Spread knob to adjust the perceived width of
the stereo or surround eld, and rotate the Xover knob to set the crossover frequency. Any
synthesized impulse response frequency that falls below this value is aected by the Spread
parameter. (These knobs are available only for synthesized impulse responses.)