X
Table Of Contents
- Logic Pro X Effects
- Contents
- Chapter 1: Amps and pedals
- Chapter 2: Delay effects
- Chapter 3: Distortion effects
- Chapter 4: Dynamics processors
- Chapter 5: Equalizers
- Chapter 6: Filter effects
- Filter effects overview
- AutoFilter
- EVOC 20 Filterbank
- EVOC 20 TrackOscillator
- EVOC 20 TrackOscillator overview
- Vocoder overview
- EVOC 20 TrackOscillator interface
- EVOC 20 TrackOscillator analysis in parameters
- Use EVOC 20 TrackOscillator analysis in
- EVOC 20 TrackOscillator U/V detection parameters
- EVOC 20 TrackOscillator synthesis in parameters
- EVOC 20 TrackOscillator oscillators
- EVOC 20 TrackOscillator formant filter
- EVOC 20 TrackOscillator modulation
- EVOC 20 TrackOscillator output parameters
- Fuzz-Wah
- Spectral Gate
- Chapter 7: Imaging processors
- Chapter 8: Metering tools
- Chapter 9: MIDI plug-ins
- Chapter 10: Modulation effects
- Chapter 11: Pitch effects
- Chapter 12: Reverb effects
- Chapter 13: Space Designer convolution reverb
- Chapter 14: Specialized effects and utilities
- Chapter 15: Utilities and tools
- Appendix: Legacy effects
Chapter 13 Space Designer convolution reverb 248
Use Space Designer EQ parameters
Space Designer has a four-band EQ consisting of two parametric mid-bands plus two shelving
lters (one low shelving lter and one high shelving lter). You can edit the EQ parameters
numerically in the parameter bar or graphically in the main display.
EQ On/Off button Individual EQ band buttons
•
EQ On/O button: Click to turn the entire EQ section on or o.
•
EQ band buttons: Click to turn individual EQ bands on or o.
•
Frequency elds: Set the frequency for the selected EQ band.
•
Gain elds: Cut or boost the selected EQ band.
•
Q elds: Set the Q factor for the two parametric bands. The Q factor can be adjusted from 0.1
(very narrow) to 10 (very wide).