X

Chapter 12 Reverb eects 232
EnVerb sound parameters
EnVerb provides the following sound parameters that change the tonal color of the reverb eect.
EnVerb sound parameters
•
Density slider and eld: Drag to set the reverb density.
•
Spread slider and eld: Drag to control the width of the reverb’s stereo image. At 0% the eect
generates a monaural reverb. At 200% the stereo base is articially expanded.
•
High Cut slider and eld: Drag to lter frequencies above the set value out of the reverb tail.
•
Crossover slider and eld: Drag to set the frequency used to split the input signal into two
frequency bands for independent processing.
•
Low Freq Level slider and eld: Drag to set the relative level of (reverb signal) frequencies below
the crossover frequency. In most cases you get better-sounding results when you set negative
values for this parameter.