X

Chapter 12 Reverb eects 231
EnVerb time parameters
EnVerb provides the following time parameters.
EnVerb time parameters
•
Dry Signal Delay slider and eld: Drag to determine the delay of the original signal. You can hear
the dry signal only when the Mix parameter is set to a value other than 100%.
•
Graphic display: Shows changes to the reverb shape when knobs below the display
are adjusted.
•
Predelay knob and eld: Rotate to set the time between the original signal and the start point
of the reverb attack phase—the very beginning of the rst reection.
•
Attack knob and eld: Rotate to set the time it takes for the reverb to climb to its peak level.
•
Decay knob and eld: Rotate to set the time it takes for the level of the reverb to drop from its
peak to the sustain level.
•
Sustain knob and eld: Rotate to set the level of the reverb that remains constant throughout
the sustain phase. It is expressed as a percentage of the full-scale volume of the reverb signal.
•
Hold knob and eld: Rotate to set the duration of the reverb sustain phase.
•
Release knob and eld: Rotate to set the time it takes for the reverb to fade out completely,
after the sustain phase.