X

Chapter 10 Modulation eects 211
Ringshifter output parameters
The output parameters are used to set the balance between the eect and input signals and also
to set the width and feedback level of the Ringshifter.
Ringshifter Output parameters
•
Dry/Wet knob and eld: Rotate to set the mix ratio of the dry input signal and the wet
eect signal.
•
Feedback knob and eld: Rotate to set the amount of signal routed back to the eect input.
Feedback adds an edge to the Ringshifter sound and is used for a variety of special eects.
•
Feedback, in combination with a slow oscillator sweep, produces a rich phasing sound.
•
A high Feedback setting with a short delay time of less than 10 ms produces
comb-ltering eects.
•
A high Feedback setting with a longer delay time produces continuously rising and falling
frequency shift eects.
•
Stereo Width knob and eld: Rotate to determine the breadth of the eect signal in the stereo
eld. Stereo Width aects only the eect signal of the Ringshifter, not the dry input signal.
•
Env(elope) Follower slider and eld: Drag to determine the amount of Dry/Wet parameter
modulation by the input signal level.
•
LFO slider and eld: Drag to set the LFO modulation depth of the Dry/Wet parameter.