X

Chapter 10 Modulation eects 207
•
Oscillator parameters: Congure the internal sine wave oscillator, which modulates the
amplitude of the input signal in both of the frequency shifter modes as well as in the ring
modulator OSC mode. See Ringshifter oscillator parameters on page 208.
•
Delay parameters: Delay the eect signal. See Ringshifter delay parameters on page 209.
•
Envelope follower parameters: Modulate the oscillator frequency and output signal with an
envelope follower. See Ringshifter envelope follower modulation on page 209.
•
LFO parameters: Modulate the oscillator frequency and output signal with an LFO. See
Ringshifter LFO modulation on page 210.
•
Output parameters: Set feedback, stereo width, and the amount of dry and wet signals. See
Ringshifter output parameters on page 211.
Set the Ringshifter mode
The four mode buttons determine whether the Ringshifter operates as a frequency shifter or as a
ring modulator.
Ringshifter mode parameters
•
Single Freq(uency) Shift(er) button: The frequency shifter generates a single, shifted eect signal.
The oscillator Frequency control determines whether the signal is shifted to a positive value
on the right side of the Frequency knob or to a negative value on the left side.
•
Dual Freq(uency) Shift(er) button: Produces one shifted eect signal for each stereo channel—
one is shifted up, the other is shifted down.
The oscillator Frequency control determines the shift direction towards the left or the
right channel.
•
OSC Ring Mod(ulator) button: The ring modulator uses the internal sine wave oscillator to
modulate the input signal.
•
Side Chain Ring Mod(ulator) button: The ring modulator modulates the amplitude of the input
signal with the audio signal assigned via the side-chain input.
The sine wave oscillator is switched o, and the Frequency controls are disabled when Side
Chain mode is active.