X

Chapter 8 Metering tools 152
MultiMeter Peak parameters
The MultiMeter Peak parameters are used to enable or disable the peak hold function and
to reset the peak segments of all meter types. You can also determine a temporary peak
hold duration.
MultiMeter Peak parameters
•
Hold button: Click to turn on peak hold for all metering tools in the MultiMeter, as follows:
•
Analyzer: A small yellow segment above each 1/3-octave level bar indicates the most recent
peak level.
•
Goniometer: All illuminated pixels are held during a peak hold.
•
Correlation Meter: The horizontal area around the white correlation indicator denotes phase
correlation deviations in real time, in both directions. A vertical red line to the left of the
correlation indicator shows the maximum negative phase deviation value. You can reset this
line by clicking it during playback.
•
Level Meter: A small yellow segment above each stereo level bar indicates the most recent
peak level.
•
Hold Time pop-up menu: Choose the hold time for all metering tools. Choose 2, 4, or 6
seconds—or innite.
Note: The (peak) Hold button must be turned on for the selected time value to have an eect.
•
Reset button: Click to reset the peak hold segments of all metering tools.
•
Inter Sample Peak Detection checkbox (Extended Parameters area): Select to detect inter-sample
peaks in the signal.