X

Chapter 6 Filter eects 13 5
EVOC 20 TrackOscillator output parameters
The output section provides control over the type, stereo width, and level of signal that is sent
from the EVOC 20 TrackOscillator.
Output parameters
•
Signal pop-up menu: Choose the signal that is sent to the plug-in’s main outputs:
•
Voc(oder): Hear the vocoder eect.
•
Syn(thesis): Hear only the synthesizer signal.
•
Ana(lysis): Hear only the analysis signal.
Note: The last two settings are mainly useful for monitoring purposes.
•
Level slider: Drag to set the overall volume of the output signal.
•
Stereo Mode pop-up menu: Choose the input/output mode.
•
In s/s mode (stereo input/stereo output), the left and right channels are processed by
separate lter banks.
•
In m/s mode (mono input/stereo output), a stereo input signal is rst summed to mono
before being routed to the lter banks.
•
Stereo Width knob: Rotate to distribute the output signals of the synthesis section’s lter bands
in the stereo eld.
•
At the 0 position to the left, the outputs of all bands are centered.
•
At the centered position, the outputs of all bands ascend from left to right.
•
At the Full position to the right, the bands are output—alternately—to the left and
right channels.