X

Chapter 5 Equalizers 111
Match EQ parameters
Match EQ oers the following parameters.
Match EQ parameters
•
Analyzer button: Turns the Analyzer function on or o.
•
Pre/Post button: Click to determine if the Analyzer looks at the signal before (Pre) or after (Post)
the lter curve is applied.
•
View pop-up menu: Set the information shown in the graphic display. Choices are:
•
Auto: Displays information for the current function, as set with the active button below the
graphic display.
•
Template: Displays the learned frequency curve template for the source le. This is shown in
red.
•
Current Material: Displays the frequency curve for the audio learned as current material. This
is shown in green.
•
Filter: Displays the lter curve created by matching the template and the current material.
This is shown in yellow.
•
View button: Determines if separate curves are displayed by the Analyzer (L&R for stereo, All
Cha for surround) or the summed maximum level is shown (LR Max for stereo, Cha Max for
surround).
Note: The View parameters are disabled when you use the eect on a mono channel.
•
Select buttons: Apply changes to the lter curve (created by matching the template with the
current material) to: the left (L), right (R), or both channels (L+R).
Note: The Select parameters are disabled when you use the eect on a mono channel.
•
Select pop-up menu (Surround instances only): Choose an individual channel or all channels.
Changes to the lter curve aect the chosen channel when a single channel is selected.
•
Channel Link slider and eld: Drag to rene settings made with the Select buttons or Select
pop-up menu.
•
When set to 100%, all channels (L and R for stereo, or all surround channels) are represented
by a common EQ curve.
•
When set to 0%, a separate lter curve is displayed for each channel (chosen with the Select
buttons or Select pop-up menu).