10.6

73Logic Pro Effects
Bitcrusher parameters
• Mode buttons: Set the distortion mode to Fold, Clip, or Wrap. Signal peaks that exceed
the clip level are processed.
Note: The Clip Level parameter has a significant impact on the behavior of all three
modes. This is reflected in the waveform display, so try each mode button and adjust
the Clip Level slider to get a feel for how this works.
• Fold button: Set a softer distortion by halving the level of the center portion of
the signal above the threshold. The start and end levels of the clipped signal are
unchanged.
• Clip button: Enable to cause an abrupt distortion when the clipping threshold is
exceeded. Clipping that occurs in most digital systems is closest to Cut mode.
• Wrap button: Set a less severe distortion by offsetting the start, mid, and end levels
of the signal above the threshold. This parameter smooths signal levels when they
cross the threshold. The center portion of the clipped signal is also softer than in
Cut mode.
• Drive knob and field: Set the amount of gain applied to the input signal.
Note: Raising the Drive level also tends to increase the amount of clipping at the effect
output.
• Resolution knob and field: Set the bit rate (between 1 and 24 bits) to alter the
calculation precision of the process. Lower values increase the number of sampling
errors, generating more distortion. At extremely low bit rates, the amount of distortion
can be greater than the level of the usable signal.
• Downsampling knob and field: Reduce the sample rate. A value of 1x has no effect on
the signal, a value of 2x halves the sample rate, and a value of 10x reduces the sample
rate to one-tenth of the original. (For example, if you set Downsampling to 10x, a
44.1 kHz signal is sampled at just 4.41 kHz.)
Note: Downsampling has no impact on the playback speed or pitch of the signal.
• Mix knob and field: Set the balance between the dry and crushed signal.
• Waveform display: Shows the impact of parameters on the distortion process.
• Clip Level handle and field: Set the point (below the clipping threshold of the channel)
at which the signal starts clipping. Drag the green dot at the top left, or the field, to
set the clip level.