10.6

49Logic Pro Effects
Logic Pro Pedalboard utility pedals
This table describes the parameters of the Mixer and Splitter pedals.
Stompbox Description
Mixer
Controls the level relationship between Bus A and Bus B signals. It can be
inserted anywhere in the signal chain but is typically used at the end of
the chain, shown at the extreme right of the Pedal area. See Use the
Logic Pro Pedalboard Router for more information.
• Mix fader: Set the level or level balance, depending on the A/Mix/B
switch position.
• A/Mix/B switch: Solo the “A” signal, mix the “A” and “B” signals, or solo
the “B” signal.
• Pan knobs: Set the pan position for each bus.
Splitter A utility that can be inserted anywhere in the signal chain. Splitter has two
modes, set with the Freq and Split switch positions. See Use the Logic Pro
Pedalboard Router for more information.
• Frequency knob: Set the frequency used to split signals when Freq
mode is active.
• Freq switch: Works as a frequency-dependent signal splitter that
divides the incoming signal. Signals above the frequency set with the
Frequency knob are sent to Bus B. Signals below this frequency are
sent to Bus A.
• Split switch: The incoming signal is routed equally to both buses.
The Frequency knob has no impact in this mode.