10.6

257Logic Pro Effects
Logic Pro Step FX global controls
The XY pad provides real-time control of up to four target parameters. Drag the blue
control point to simultaneously modulate your targets. The parameters of the XY pad
and the Master controls are described in the respective sections below.
XY pad parameters
Changes to XY pad Target pop-up menus are reflected by blue rings and dots around
target parameter knobs, which make it easy to identify a target parameter. The rings
indicate the modulation range and the dots indicate the current value of the XY
pad modulation.
• XY pad: Drag horizontally or vertically to change the value of the assigned X or Y
target parameters.
• On/off buttons: Enable/disable the X or Y controller.
• X Target pop-up menus: Choose one or two modulation targets from any active effect
processor, modulation source, or master control section.
• X Depth fields: Set the modulation amount/range for the chosen X target(s).
• Y Target pop-up menus: Choose one or two modulation targets from any active effect
processor, modulation source, or master control section.
• Y Depth fields: Set the modulation amount/range for the chosen Y target(s).
Master controls
• Input knob and field: Set the input level of the plug-in.
• Mix knob and field: Set the level of the original versus processed signal. This is
essentially a wet/dry balance control.
• Output knob and field: Set the overall output level of the plug-in.
Effects order strip
The order and status of active and inactive effects units are indicated in the strip.
Inactive effects are dimmed, and active effects are illuminated. The signal flow runs
from left to right.
Effects order strip: Drag the name of an active (lit) or inactive (dimmed) effect horizontally
to change the effects order.