10.6

Table Of Contents
896Logic Pro User Guide
In Logic Pro, do any of the following:
Move the L or R puck in the surround field to move the second puck in a symmetrical
fashion.
Drag the third puck to move both the L and R pucks, while maintaining a given spread.
Left/right movement changes the angle of both.
Up/down movement changes the diversity.
The circular bars around the panner indicate which speakers will carry the respective
signal source; the closer to the center a puck is moved, the wider the corresponding bar
gets (the greater the diversity, in other words).
Use the Surround Balancer on surround input channel strips
In Logic Pro, if the source input is set to surround, the Surround Panner acts as a Surround
Balancer control. For more information, see Set the channel strip input format in Logic Pro.
Source channels are passed on to their respective output channels without any cross-
panning or mixing. The pan control is represented by a single puck, which affects the
multichannel source signal as a whole.
The separation parameters are not available in this Surround Panner mode.
Drag the puck to change relative volume balance of the source signal.