10.6

525Logic Pro User Guide
MIDI Transform window examples in Logic Pro
This section provides several usage examples for the MIDI Transform window in Logic Pro.
Add a mod wheel controller event (#1) with a value that matches the
note’s velocity
1. In Logic Pro, choose the following settings in the MIDI Transform window:
• Mode pop-up menu:Copy selected events, then apply operations.
• Selection Conditions area:Set Status to Note.
• Operations area:
• Set Position to Add, then enter a value of 1 in the field below it.
• Set Status to Fix, then choose Control from the pop-up menu below it.
• Set Pitch to Fix, then enter a value of 1 in the field below it. This means “the
first data byte receives the value of 1” (the first data byte defines the controller
number for controller events, and mod wheel events happen to be #1).
Note: When you convert MIDI note events to controller events, two controller events
are created:one for the note on event, and one for the note off event.
2. Click Select and Operate.
If you analyze these settings, you’ll see that all note events are selected for operation. A
copy of each is made, then moved one tick later than the original, and converted to CC#1
(mod wheel), with a value that corresponds to the velocity of the original note. This is
because the second data byte (Vel) is left unaltered.
The automatic offset by one tick after each note start point and end point avoids potential
conflicts with the source note events.