10.6

Table Of Contents
136Logic Pro User Guide
Use additional transport buttons
In Logic Pro, click any of the following:
Go to Beginning button: Moves the playhead to the start of the project.
Go to Position button: Moves the playhead to a target bar or time position that you
specify in the Go to Position dialog.
Go to Left Locator button: Moves the playhead to the left locator position shown in the
ruler. The left locator defines the cycle area start point. Use the cycle area to repeatedly
play, or record over, a section.
Go to Right Locator button: Moves the playhead to the right locator position shown
in the ruler. The right locator defines the cycle area end point. Use the cycle area to
repeatedly play, or record over, a section.
Go to Selection Start button: Moves the playhead to the start point of the first selected
region or event. You can also pressShift-Return.
Play from Beginning button: Plays from the start of the project.
Play from Left Window Edge button: Plays from the leftmost visible point in the active
workspace.
Play from Left Locator button: Plays from the left locator position shown in the ruler.
The left locator defines the cycle area start point. Use the cycle area to repeatedly play,
or record over, a section.
Play from Right Locator button: Plays from the right locator position shown in the ruler.
The right locator defines the cycle area end point. Use the cycle area to repeatedly play,
or record over, a section.
Play from Selection button: Plays from the start point of the first selected region or
event. You can also pressShift-Return.
Pause button: Pauses playback or recording, until you click either the Pause or Play
button.
Capture Recording button: Captures the most recent performance, even if Logic Pro
was not in record mode while you were playing.