X

Chapter 2 Basic control surface setup 31
Control surfaces supported by Logic Pro
The table shows control surfaces directly supported by Logic Pro.
Supported control surfaces communicate with Logic Pro via special plug-in les that are installed
with the application. The plug-in les are located in the /Contents/MIDI Device Plug-ins subfolder
of the Logic Pro application bundle. To view the bundle contents, Control-click the Logic Pro
application icon, and choose Show Package Contents from the shortcut menu. Logic Pro also
checks for control surface plug-ins installed in the ~/Library/Application Support/MIDI Device
Plug-ins and ~/Library/Application Support/MIDI Device Plug-ins folders.
When new control surface plug-ins are released independently of a Logic Pro update (or
supplied directly by the device manufacturer), place them in the folders described above or as
advised in the documentation supplied with the plug-in.
Supported devices Manufacturer Notes
01V96 Yamaha
The Yamaha 01V96 emulates two
HUI units, using two virtual MIDI In
and Out connections over a USB
cable. See Set up your 01V96
on
page 235.
01X Yamaha
The Yamaha 01X emulates a
Mackie Control. It does not
feature all controls available to
the Mackie units, however. Refer
to the 01X documentation for
details. Logic Pro recognizes the
01X as an 01X, and displays a
custom icon, but communication
is as with a Mackie Control unit.
See Mackie Control overview on
page 54.
02R96 Yamaha
The Yamaha 02R96 emulates three
HUI units, using three virtual MIDI
In and Out connections over a USB
cable. See Set up your 02R96
on
page 247.
Baby HUI Mackie The Baby HUI is a smaller version
of the HUI. See Set up your
Baby HUI on page 158 .
C4 Mackie
The Mackie C4 is directly
supported. See Set up of your
C4
on page 180.
CM408T (System 5-MC) Euphonix See Set up your Euphonix
device
on page 113 .
CS-32 MiniDesk JLCooper See
Set up your CS-32 MiniDesk on
page 140.
DM1000 Yamaha
The Yamaha DM1000 emulates two
HUI units, using two virtual MIDI In
and Out connections over a USB
cable. See Set up your DM1000
on
page 254.