X

Chapter 2 Basic control surface setup 25
Control Surface Group other parameters
The parameters at the bottom of the Control Surface Group parameters area let you set global
group parameters.
Other parameters
•
Track Name Format: Choose whether the track name display shows only the track name or the
track name and number.
•
Parameter Page Shift Mode: Choose whether the parameter is shifted by one page or by
one parameter.
•
Relative Change Mode: Choose the mode for controller assignments that support a Relative
Value Change mode (rotary encoders, for example). The choices are:
•
Coarse: The parameter is adjusted in coarse steps.
•
Full: Rotating the encoder to the right sets the maximum value and rotating it to the left
sets the minimum value. The encoder also stops at its default value. For example, when the
Pan knob is left of center, turning the encoder to the right initially sets the Pan parameter
to the center position (its default value). A further turn to the right sets Pan to full right (its
maximum value).
•
Fine: The parameter is incremented or decremented in ne steps—by one tick or other unit.
In this mode, the highest possible resolution is used. For example, when editing the Sample
Delay plug-in’s Delay parameter, every encoder tick increases or decreases the value by 1
sample, regardless of the resolution value.
•
Mix Group: Drag vertically, or enter an integer value to determine which group is edited when
in Group Edit mode.
•
Group Parameter Page: Drag vertically, or enter an integer value to dene which parameter of
the edited group is assigned to the leftmost encoder.