X

Chapter 20 Tascam US-2400 222
US-2400 channel strips
The table outlines the channel strip controls and their assignments.
Note: A modier button, such as SHIFT, below a control description indicates that the control has
an alternate use while the modier is held down.
Control Modier Assignment
Encoders CHAN button on: see US-2400
encoders on page 223.
CHAN button ashing: encoders
control Instrument parameters.
Also see Instrument Edit view
on
page 227.
PAN button ashing: encoders
control plug-in parameters. Also
see Plug-in Edit view
on page 227.
Other modes: encoders control the
parameters of the active mode.
F-KEY
•
If you are in Instrument Edit
view (CHAN button ashing),
pressing the F-Key enters the
Instrument Assignment view.
The encoders are used to
choose an instrument plug-in
from the list (of available
software instrument plug-ins).
•
If you are in Plug-in Edit view
(PAN button ashing), pressing
the F-Key enters the Plug-in
Assignment view. The encoders
are used to choose an eect
plug-in from the list (of available
eect plug-ins).
•
If you are in Send view (AUX
button LED ashes) and press
the F-Key, the encoders are used
to assign the send destination.
SEL buttons Selects tracks/channels.
SHIFT In Pan view: sets volume to Unity
(0 dB).
In Send views: switches the Send
mode (pre/post).
F-KEY Turns the Record Enable button of
each channel on or o.
SOLO buttons Enables or disables Solo.
MUTE buttons Enables or disables Mute. In Send
views with Flip mode enabled:
mutes/unmutes the selected Send.
SHIFT In Send views: mutes/unmutes the
selected Send.
Faders Controls the volume of each
channel (unless Duplicate or Swap
Flip mode is active).