X

221
Set up your US-2400
The US-2400 is capable of running in both native and Mackie Control emulation modes. If the
unit is set up in Mackie Control emulation mode, and the native support plug-in is installed
in the Logic Pro program bundle, Logic Pro detects a US-2400 native control surface and a
Mackie Control, plus two Extender (XT) units.
To run the US-2400 in Mackie Control mode, remove the US-2400 plug-in from the Logic Pro
application bundle. Logic Pro will then detect a Mackie Control plus two Extender (XT) units
(the appropriate setup for the US-2400 in Mackie Control emulation mode) when you scan for
control surfaces.
The button layout of the Mackie Control diers from that of the Tascam US-2400. When running
the Tascam US-2400 in Mackie Control mode, certain controllers are not accessible (the Joystick,
for example). Given these restrictions, use of the Tascam US-2400 in Mackie Control mode
is not recommended. If you choose to do so, refer to the documentation supplied with the
Tascam US-2400 for details.
Follow the steps below to use your Tascam US-2400 with Logic Pro.
Set up the Tascam US-2400 for use with Logic Pro
1 Make sure that your US-2400 control surfaces are connected to the computer via USB.
2 Ensure that the US-2400 is in native mode. Consult your US-2400 manual for more information
on this setting.
3 Open Logic Pro.
Your control surfaces are scanned for, and installed, automatically.
US-2400 assignments
US-2400 assignments overview
These sections outline the assignment of Tascam US-2400 interface elements to Logic functions.
•
US-2400 channel strips on page 222
•
US-2400 encoders on page 223
•
US-2400 master channel on page 225
•
US-2400 encoder assignments overview on page 226
•
US-2400 master section controls on page 228
Tascam US-2400
20