X

Chapter 19 Tascam FW-1884 218
Automation controls (FW-1884 only)
The table outlines the automation controls and their assignments:
Control Assignment
READ While READ is held down, SEL buttons are lit if a
channel strip is in Read automation mode. Pressing
the SEL button sets Read mode. Turning the encoder
also edits the automation mode.
WRITE While WRITE is held down, SEL buttons are lit if a
channel strip is in Write automation mode. Pressing
the SEL button sets Write mode. Turning the encoder
also edits the automation mode.
TCH While TCH is held down, SEL buttons are lit if a
channel strip is in Touch automation mode. Pressing
the SEL button sets Touch mode. Turning the encoder
also edits the automation mode.
LATCH While LATCH is held down, SEL buttons are lit if a
channel strip is in Latch automation mode. Pressing
the SEL button sets Latch mode. Turning the encoder
also edits the automation mode.
F7 Switches encoders to editing of pan/surround
parameters on selected channel strip. Surround
parameters are shown as follows: angle, radius, LFE
(level), Spread mode, X, Y, Center (level).
F8 Switches encoders to Channel view: EQ Edit mode for
the selected channel strip. In this mode, the encoders
are used to edit the EQ parameters, while the left/
right cursors are used to shift the EQ parameter bank
(parameter group).
F9 Switches encoders to Channel view: Plug-in Edit mode
for the selected channel strip. In this mode, the left/
right cursors are used to shift the plug-in parameter
bank. The up/down cursors are used to choose the
channel strip Insert slot for editing.
F10 Switches encoders to Channel view: Instrument Edit
mode for the selected channel strip. In this mode,
the left/right cursors are used to shift the instrument
parameter bank.