X

Chapter 19 Tascam FW-1884 214
EQ controls (FW-1884 only)
The EQ controls apply to a certain EQ band of the selected channel. A Channel or Linear Phase
EQ is automatically inserted in the channel, if not already present.
Note: If a modier button, such as SHIFT, is shown below a button description, it indicates that
the control has an alternate use while the modier is held down.
Mode Modier Assignment
REC While REC is held down,
the SEL buttons activate or
deactivate Record Enable for the
corresponding channel strip.
GAIN Edits the Gain of the currently
selected EQ band.
SET Selects the channel strip input.
FREQ Edits the Frequency parameter of
the currently selected EQ band.
SET Selects the channel strip output.
Q Edits the Q Factor of the currently
selected EQ band.
SET Selects the channel strip input
format.
HIGH Selects EQ band 6.
SHIFT Selects EQ band 8.
REC Switches the bypass state of EQ
band 6 (driver version 1.20 or later
required).
HI-MID Selects EQ band 5.
SHIFT Selects EQ band 7.
REC Switches the bypass state of EQ
band 5 (driver version 1.20 or later
required).
LOW-MID Selects EQ band 4.
SHIFT Selects EQ band 2.
REC Switches the bypass state of EQ
band 4 (driver version 1.20 or later
required).
LOW Selects EQ band 3.
SHIFT Selects EQ band 1.
REC Switches the bypass state of EQ
band 3 (driver version 1.20 or later
required).