X

Chapter 19 Tascam FW-1884 213
Channel strips (FW-1884, FE-8, FW-1082)
The table outlines the channel strip controls and their assignments.
Note: If a modier button, such as SHIFT, is shown below a button description, it indicates that
the control has an alternate use while the modier is held down.
Control Modier Assignment
REC LEDs These LEDs are lit when the
corresponding channel strip is
recording. The LEDs ash when the
channel strip is in Record Enable
mode (armed).
SEL Selects the channel strip.
SHIFT Enables or disables Send bypass,
when encoders are controlling a
Send level.
READ Sets the track automation mode
to Read.
WRITE Sets the track automation mode
to Write.
TCH Sets the track automation mode
to Touch.
LATCH Sets the track automation mode
to Latch.
SOLO Enables or disables the Solo state
of the channel strip.
SHIFT Disables the Solo state for all
channel strips (driver version 1.20
or later required).
MUTE Enables or disables the Mute state
of the channel strip.
SHIFT Disables the Mute state for all
channel strips (driver version 1.20
or later required).
Encoder Controls the parameter chosen
with the ENCODERS section.
SET When encoders are controlling a
Send level, this combination allows
you to set the send destination.
Fader Controls the channel strip volume.
Master fader Controls the master volume. If no
master channel exists, it controls
Output 1/2.