X

Chapter 14 Mackie HUI 164
HUI assign controls
The table outlines the controls in the ASSIGN section and their assignments.
Note: A modier button, such as SHIFT, below a button description indicates that the button has
an alternate use while the modier is held down.
Control Modier Assignment
SEND A Assigns Send 1 level to V-Pots, and
Send 1 to 4 levels to DSP V-Pots.
While SEND A is held down, the
scribble strips show the current
Send 1 destination (a bus number).
SHIFT/ADD As above, for Send 6
SEND B As above, for Send 2
SHIFT/ADD As above, for Send 7
SEND C As above, for Send 3
SHIFT/ADD As above, for Send 8
SEND D As above, for Send 4
SEND E As above, for Send 5
PAN Assigns Pan to V-Pots, and the
selected (surround) channel strip’s
pan/surround parameters to
DSP V-Pots. You must conrm any
changes made with the DSP V-Pots
by pressing the corresponding
V-Select button.
INPUT Assigns channel strip input to
V-Pots. While held down, the
scribble strips show the current
channel strip input assignment.
The four DSP V-Pots control the
following parameters of the
selected channel strip: format,
input, output, and automation
mode. You must conrm any
changes made with the V-Pots
or DSP V-Pots by pressing the
corresponding V-Select button.
OUTPUT Assigns channel strip output to
V-Pots. While held down, the
scribble strips show the current
channel strip output assignment.
The four DSP V-Pots control the
following parameters of the
selected channel strip: format,
input, output, and automation
mode. You must conrm any
changes made with the V-Pots
or DSP V-Pots by pressing the
corresponding V-Select button.
REC/RDY ALL Disables Record Enable button of
all channel strips.