X

162
Set up your HUI
HUI control surface devices don’t support automatic scanning. You need to manually add these
devices to your setup. When you add a device in this way, you need to assign the MIDI In and Out
port parameters.
Important: There are a number of control surfaces—not mentioned in this guide—that can
emulate the HUI. Such devices are not supported by Apple, nor are they guaranteed to work with
Logic Pro in HUI emulation mode.
If the unit emulates a single HUI device, proceed as if using a HUI.
If you experience problems in the DSP Edit display, install the unit as a DM2000. See Set up your
DM2000 on page 266.
If the unit emulates more than one HUI, add the required number of additional devices in the
Setup window. If the unit is limited to support of only one HUI DSP Edit section, choose “HUI
Channel Strips only” as the model name for these additional units. This ensures that scrolling in
the DSP Edit section is limited to four parameters.
If you want to know more about button assignments, refer to HUI assignments overview on
page 163 and the user manual for the device.
Set up Mackie HUI devices
1 Make sure that your HUI devices are connected bidirectionally with the computer, using a
MIDI interface.
2 Choose Logic Pro > Control Surfaces > Setup.
3 Choose New > Install in the Setup window.
4 Select HUI in the Install window.
5 Click the Add button.
6 Select the added device in the Setup window, then set the MIDI In and MIDI Out parameters
as appropriate.
Mackie HUI
14