X

158
Set up your Baby HUI
Baby HUI control surface units do not support automatic scanning. You need to manually add
these devices to your setup. When you add a device in this way, you need to specify the MIDI In
and Out port parameters.
Set up Mackie Baby HUI units
1 Make sure that your Baby HUI units are connected bidirectionally with the computer, using a
MIDI interface.
2 Choose Logic Pro > Control Surfaces > Setup.
3 Choose New > Install in the Setup window.
4 Select the Baby HUI in the Install window.
5 Click the Add button.
6 Select the added device in the Setup window, then assign the MIDI Input and MIDI Out
parameters as appropriate.
Baby HUI assignments
Baby HUI assignments overview
Assignments of Mackie Baby HUI interface elements to Logic functions are covered in the
following sections:
•
Baby HUI channel strips on page 159
•
Baby HUI encoder assignment controls on page 159
•
Baby HUI automation controls on page 160
•
Baby HUI display controls on page 160
•
Baby HUI utility controls on page 160
•
Baby HUI navigation controls on page 161
•
Baby HUI transport controls on page 161
Mackie Baby HUI
13