X

Chapter 12 Korg microKONTROL and KONTROL49 157
microKONTROL and KONTROL49 channel strips
There are several modes for the encoders, enabled with SCENE and Pad 9–16.
Control Assignment
LCD Shows the parameter controlled by the encoder. The
current name/value is displayed for a few seconds
when you move an encoder or a fader. When the
encoders are in a Mixer view (Pan, Send, Send
Setup), the background color indicates the channel
automation mode:
•
Green: O or Read
•
Yellow: Touch or Latch
•
Red: Write
Encoder Controls the parameter shown directly above the
encoder in the LCD.
Fader Controls volume. Because the faders don’t oer
feedback, Pickup mode is used (if enabled in the
Control Surfaces preferences). This means that the
fader must reach (“pick up”) the current parameter
value before the value starts to change.
microKONTROL and KONTROL49 external input
The table outlines the external input controls and their assignments:
Control Assignment
Foot Switch Starts and stops playback.
Pedal Controls the master fader.