X

149
Set up your MCS3
Logic Pro supports USB or MIDI versions of the JLCooper MCS3 control surface. Both USB
and MIDI versions are installed automatically when you open Logic Pro. If your MCS3 is not
recognized and installed correctly, follow the steps below.
Add JLCooper MCS3 control surfaces connected via USB
1 Ensure that your MCS3 USB device is correctly connected to the computer with a USB cable. Also
ensure that the unit is powered.
2 Open Logic Pro.
The MCS3 is added to the Control Surfaces Setup window.
Add JLCooper MCS3 control surfaces connected via MIDI
1 Make sure that your MCS3 units are connected to the computer via MIDI.
2 Choose Logic Pro > Control Surfaces > Setup.
3 Choose Install from the Setup window’s New menu.
4 Select the MCS3 from the list in the Install window.
5 Click the Scan button.
MCS3 assignments
MCS3 assignments overview
Assignments of JLCooper MCS3 interface elements to Logic functions are covered in these
sections:
•
MCS3 F1 to F6 buttons on page 150
•
MCS3 W1 to W7 buttons on page 150
•
MCS3 cursor controls on page 150
•
MCS3 Jog wheel and Shuttle ring on page 151
•
MCS3 transport controls on page 151
JLCooper MCS3
11