X

148
Set up your FaderMaster 4/100
You can combine several FaderMaster 4/100 devices to form one large virtual control surface.
The meaning and functionality of the Track buttons, however, are individually switched for
each device.
Before using your FaderMaster 4/100 control surface with Logic Pro, you should make sure that
your FaderMaster 4/100 (MIDI or USB version) has rmware version 1.03 or later installed. If you
have older rmware (see the sticker on the back of the unit), contact JLCooper.
Connect your FaderMaster 4/100 devices to the computer via USB or MIDI. If connected via USB,
installation is automatic.
Note: USB model only: Install the software that comes with the FaderMaster 4/100.
Install JLCooper FaderMaster 4/100 units connected via MIDI
1 Choose Logic Pro > Control Surfaces > Setup.
2 Choose Install from the New menu.
3 Select FaderMaster 4/100 from the list in the Install window.
4 Click the Scan button.
FaderMaster 4/100 assignments
The table outlines the global controls and their assignments:
Control Assignment
Select Switches Track buttons to track selection duties.
Aux Switches Track buttons to emulate Record Enable
buttons.
Solo Switches Track buttons to emulate Solo buttons.
Mute Switches Track Buttons to emulate Mute buttons.
Inc Increases fader bank display to show next four
channels.
Dec Decreases fader bank display to show previous four
channels.
The table outlines the channel strip controls and their assignments:
Control Assignment
Track button Performs currently selected function (Select, Record
Enable, Solo, Mute).
Fader Controls volume (touch-sensitive and motorized).
JLCooper FaderMaster 4/100
10