X

135
Set up your TranzPort
Follow the steps below to use your Frontier Design TranzPort control surface with Logic Pro.
Note: Support for the AlphaTrack control surface is available from Frontier Design.
Set up your Frontier Design TranzPort device in Logic Pro
1 Ensure that the software that shipped with the TranzPort is installed.
2 Make sure that the Tranz Bridge (the wireless transmitter) is connected to the computer via USB.
When Logic Pro is opened, it installs the TranzPort automatically, and sets it to native mode.
These sections outline the assignment of Frontier Design TranzPort interface elements to
Logic functions.
•
TranzPort channel strip on page 136
•
TranzPort master controls on page 137
TranzPort LCD
The LCD displays the following information:
•
Top line left: Name of currently displayed channel
•
Top line middle: Volume level of currently displayed channel
•
Top line right: Pan position of currently displayed channel
•
Bottom line left: Level meter of currently displayed channel
•
Bottom line right: Current playhead position
Frontier Design TranzPort
8