X

Chapter 7 CM Labs Motormix 133
Motormix left function buttons
The table outlines the left function button controls and their assignments.
Note: If a modier button, such as SHIFT, is shown below a button description, it indicates that
the control has an alternate use while the modier is held down.
Control Modier Assignment
AUTO ENBL/mode Currently unassigned
SHIFT Switches rotary encoders to
Automation Enable mode.
SUSPEND/create While held down, the groups are
temporarily disabled.
SHIFT Creates a new group, and enters
Group Edit mode.
PLUG-IN/compare Switches rotary encoders and Multi
buttons to Eect Assign mode. Use
the Rotary Select knob to choose
the Insert slot you want to edit. In
Eect or Instrument Assign mode,
it switches to Pan mode. In Eect
Edit mode, it switches to Eect
Assign mode. In Instrument Edit
mode, it switches to Instrument
Assign mode.
SHIFT Switches the rotary encoders and
Multi buttons to Instrument Assign
mode.
WINDOW/tools Switches the Select buttons to
Window Select mode.
SHIFT Switches the Select buttons to
Select Tool mode.
ALL/ALT/FINE While ALL/ALT/FINE is held down,
rotary encoders are in Full mode:
rotating counterclockwise sets
minimum; rotating clockwise sets
maximum value.
SHIFT While SHIFT and ALL/ALT/FINE are
held down, the rotary encoders are
in Fine mode. Parameter changes
are made in single unit (or smaller)
values.
DEFAULT/bypass Currently unassigned
SHIFT In Instrument Edit mode: switches
bypass state of the instrument. In
Eect Edit mode: switches bypass
state of the eect being edited.
UNDO/save Performs an Undo step. The LED is
lit if there is a Redo step available.
SHIFT Saves the project. The LED is lit
if the project contains unsaved
changes.