X

Chapter 6 Euphonix devices 124
Remove a channel strip from a group
1 Press the Group knob top, or key, to display the list of groups that the currently selected channel
strip is assigned to. This key is labeled Grp on the CM408T channel strip.
Note: If using the MC Mix, press the CHAN key to enter Channel mode.
2 Press the knob top that features the name of the group you want to remove the channel
strip from.
That particular channel is removed from the group.
Tip: The On key can also be used to switch between active and inactive group membership for
the selected channel strip.
3 Press the Back key to return to the top-level knobset.
Use the Mix or Output knobset
This knobset allows you to change the mix or output destination of a channel strip.
Change the output destination of a channel strip
1 Press the Mix or Output knob top, or key, to display all possible mix or output values for the
currently selected channel strip.
Note: If using the MC Mix, press the CHAN key to enter Channel mode.
The value names are displayed on the Soft Keys, the touchscreen, or the display, depending on
the system you are using.
2 To select the output destination, do one of the following:
•
Press the knob top that features the name of the mix or output value.
•
Press the On key for the relevant mix or output value.
You can use the Page keys to display ensuing outputs.
The currently active output is indicated by a lit On key (on the MC Professional and MC Mix
devices). On the MC Control, it is indicated by a small green LED in the lower left of the
knob image.
3 Press the Back key to return to the top-level knobset.
Euphonix Logic Pro features
This section describes other features specic to Logic Pro.
•
Layouts: Tracks assigned to channel strips can be saved as a Layout. This Layout can then be
recalled at a later time. Any Layouts saved on Euphonix devices are automatically saved with
the Logic Pro project.
•
Monitors and Control Room: Logic Pro does not support EuCon monitoring control. Use the
Studio Monitor Pro application.
•
Control Surface bar: The control surface bar of the Logic Pro Tracks window oers a special
feature on the Euphonix devices: it shows attentioned tracks in blue.
Note: The color of the control surface bar cannot be changed in the Control Surfaces Setup
window.