X

Chapter 6 Euphonix devices 121
Use the EQ knobset
This knobset allows you to edit the rst Channel or Linear Phase EQ inserted in the selected
channel strip.
There are two pages, each showing four EQ bands on eight knobs:
•
One page contains the parameters of EQ bands 1, 2, 7, and 8.
•
One page contains the parameters of EQ bands 3, 4, 5, and 6.
When no Channel or Linear Phase EQ is present on the selected channel strip, pressing the knob
top labeled AddChEQ inserts a Channel EQ.
•
The rst knob of an EQ band (the upper or left knob of the pair) controls either Frequency
or Q. To switch between Frequency and Q, use the Select/SEL key if working with the
MC Professional devices or the MC Mix. If using the MC Control, press the Shift key while
touching the knob’s image on the touchscreen. (When active, a small yellow LED lights on
the upper left of the image.) Pressing the knob top sets the controlled parameter to its
default value.
•
The second knob of an EQ band (the lower or right knob of the pair) controls Gain (or Slope).
Pressing the knob top sets the controlled parameter to its default value.
•
If working with the MC Professional devices or the MC Mix, the On key switches the bypass
state of the band. On the MC Control, press the knob’s touchscreen image.
Edit an EQ plug-in
1 Press the EQ knob top, or key, to display the EQ bands of the EQ plug-in inserted in the currently
selected channel strip.
Note: The MC Mix automatically switches to Channel mode.
The EQ band parameters are displayed on the Soft Keys, the touchscreen, or the display,
depending on the system you are using.
You can use the Page keys to display ensuing parameters.
2 Rotate the respective knob to change the parameter value.
Pressing a knob top sets the controlled parameter to its default value.
3 Press the Back key to return to the top-level knobset.