X

Chapter 5 M-Audio iControl 109
Use iControl locators and Cycle mode
The left and right locators are used to mark a section of your project. These are often used in
conjunction with cycle facilities, which repeatedly play back the section of your project between
the locators.
Set left and right locators and turn on Cycle mode
1 Use the Jog Wheel to move the playhead to the left locator position, then press both the Cycle
and Rewind buttons.
2 Do one of the following:
•
Navigate to the position where you want to set the right locator with the Jog Wheel, then
press the Cycle and Fast Forward buttons simultaneously.
•
Hold down the Cycle button, navigate to the position where you want to set the right locator
using the Jog Wheel, then release the Cycle button.
•
Rotating the Jog Wheel counterclockwise (to the left) while holding down Cycle denes a
skip-cycle range.
iControl Master fader
Move the Master fader on the iControl to set the level of the Master fader in the Logic Pro Mixer.
The Master fader changes the level of all output channels, but does not aect the relative levels
of channels that precede the Master fader in the signal path. Move the fader left to decrease the
master level, or to the right to increase the master level.