7

Chapter 24 Sculpture 391
Velocity Modulations
The Excite Objects and the Filter have dedicated velocity sensitivity controls. Many other
modulation routings also allow you to select Velocity as a via input source.
In some cases, it may be of use/interest to directly control other synthesis core
parameters by velocity. This can be done in this section—where two independent
destination/amount/velocity curve slots are available. To activate either, click on the 1
or 2 buttons.
Target 1/2
Click-hold on the respective Target pull-down menu to select the destination parameter
that you wish to modulate by velocity.
Amount 1/2
The slider below each Target determines the amount of modulation.
Curve 1/2
Click on the appropriate radio button to select from concave, linear, and convex velocity
curves.
Controller A and B
These parameters allow you to define two discrete modulation targets, and the
strength/intensity of modulation for both Controller A and B.
To use, simply click on the 1 or 2 buttons, select the desired Target (and Target mode),
and adjust the Intensity slider.
Each Target features a two-state button:
• Cont: continuous modulation
• Note On: modulation value is only updated when a note on message is received.