10.6

99Control Surfaces Support Guide
JLCooper MCS3
Set up your JLCooper MCS3 in Logic Pro
Logic Pro supports USB or MIDI versions of the JLCooper MCS3 control surface. Both USB
and MIDI versions are installed automatically when you open Logic Pro. If your MCS3 is not
recognized and installed correctly, follow the steps below.
Add JLCooper MCS3 control surfaces connected via USB
To use with Logic Pro:
1. Ensure that your MCS3 USB device is correctly connected to the computer with a USB
cable. Also ensure that the unit is powered.
2. Open Logic Pro.
The MCS3 is added to the Control Surfaces Setup window.
Add JLCooper MCS3 control surfaces connected via MIDI
To use with Logic Pro:
1. Make sure that your MCS3 units are connected to the computer via MIDI.
2. Choose Logic Pro > Control Surfaces > Setup.
3. Choose Install from the Setup window’s New menu.
4. Select the MCS3 from the list in the Install window.
5. Click the Scan button.
MCS3 assignments
Overview of JLCooper MCS3 assignments in Logic Pro
Assignments of JLCooper MCS3 interface elements to Logic Pro functions are covered in
these sections.
• JLCooper MCS3 F1 to F6 buttons in Logic Pro
• JLCooper MCS3 MCS3 W1 to W7 buttons in Logic Pro
• JLCooper MCS3 cursor controls in Logic Pro
• JLCooper MCS3 Jog wheel and Shuttle ring in Logic Pro
• JLCooper MCS3 transport controls in Logic Pro