10.6

97Control Surfaces Support Guide
JLCooper FaderMaster 4/100
Set up your JLCooper FaderMaster 4/100 in
Logic Pro
You can combine several FaderMaster 4/100 devices to form one large virtual control
surface. The meaning and functionality of the Track buttons, however, are individually
switched for each device.
Before using your FaderMaster 4/100 control surface with Logic Pro, make sure your
FaderMaster 4/100 (MIDI or USB version) has firmware version 1.03 or later installed. If you
have older firmware (see the sticker on the back of the unit), contact JLCooper.
Connect your FaderMaster 4/100 devices to the computer via USB or MIDI. If connected via
USB, installation is automatic.
Note: USB model only: Install the latest driver software available from the manufacturer.
It is possible that the current driver may not work in future macOS updates. In this case,
please contact JLCooper or connect your device bi-directionally with your MIDI interface.
Install JLCooper FaderMaster 4/100 units connected via MIDI
1. Choose Logic Pro > Control Surfaces > Setup.
2. Choose Install from the New menu.
3. Select FaderMaster 4/100 from the list in the Install window.
4. Click the Scan button.
JLCooper FaderMaster 4/100 assignments in
Logic Pro
The table outlines the global controls and their assignments:
Control Assignment
Select Switches Track buttons to track selection duties.
Aux Switches Track buttons to emulate Record Enable buttons.
Solo Switches Track buttons to emulate Solo buttons.
Mute Switches Track Buttons to emulate Mute buttons.