10.6

92Control Surfaces Support Guide
• Instrument edit mode: Press F8 to enter Instrument edit mode (display shows “In”). The
pots control (software) instrument parameters. Hold down SHIFT (display shows “b1”–
“b9”) to move between banks (pages) of parameters. (See JLCooper CS-32 MiniDesk
cursor controls in Logic Pro.)
• Effect edit mode: Press F9 to enter Effect edit mode (display shows “P1”–“P9”). The
pots control the parameters of the effect in the currently selected Insert slot. Hold
down SHIFT (display shows “b1”–“b9”) to switch between Insert slots, and move
between banks (pages) of parameters. (See JLCooper CS-32 MiniDesk cursor controls
in Logic Pro.)
• Pan/Send mode: Press F7 to enable Pan/Send mode (display shows “PA”). In this mode,
the pots control the following channel parameters:
Control Assignment
SEND A/P1 Controls Send 1 level of selected channel.
SEND B/P2 Controls Send 2 level of selected channel.
PAN/P3 Controls pan of selected channel.
SEND C/P4 Controls Send 3 level of selected channel.
SEND D/P5 Controls Send 4 level of selected channel.
SEND E/P6 Controls Send 5 level of selected channel.
While SHIFT is held down (display shows “AS”), the pots allow you to perform the following
assignments:
Control Assignment
SEND A/P1 Assigns Send 1 destination (bus) for selected channel.
SEND B/P2 Assigns Send 2 destination for selected channel.
PAN/P3 Assigns input format of selected channel.
SEND C/P4 Assigns Send 3 destination for selected channel.
SEND D/P5 Assigns Send 4 destination for selected channel.
SEND E/P6 Assigns Send 5 destination for selected channel.
JLCooper CS-32 MiniDesk channel strips in Logic Pro
The table outlines the channel strip controls and their assignments:
Note: If a modifier button, such as SHIFT, is shown below a description, it indicates that the
control has an alternate use while the modifier is held down.
Control Modifier Assignment
PAN SELECT/TRACK SELECT Selects channel strip (destination
for the selected track).
SOLO Enables or disables Solo.