10.6

91Control Surfaces Support Guide
• JLCooper CS-32 MiniDesk Jog wheel controls in Logic Pro
JLCooper CS-32 MiniDesk display in Logic Pro
The display shows information on the current mode and parameters being edited.
Display text Meaning
-- A switching parameter (Solo, Mute, Rec/Rdy) has been disabled.
AE Automation Enable setup: Mute buttons 1–6 display/set various automation
parameters.
AS Pots (knobs) are in Pan/Send Assignment mode.
b1—b9 Pots are in Plug-in or Instrument Bank Select mode.
In Pots are in Instrument Edit mode.
Lt Mute buttons display/set Latch automation mode.
Mu Mute has been enabled.
P1—P9 Pots are in Effect Edit mode.
PA Pots are in Pan/Send mode.
rd Mute buttons display/set Read automation mode.
Re Rec/Rdy has been enabled.
So Solo has been enabled.
Tc Mute buttons display/set Touch automation mode.
Wr Mute buttons display/set Write automation mode.
Other text When a channel is selected, the first two characters of its name are briefly
displayed.
Numbers While editing a numerical value with a fader or pot, the current value is
displayed. If there are more than two digits in the value, the last two digits
are shown. Plus/minus signs (+/–) are shown if only one digit is displayed.
JLCooper CS-32 MiniDesk pots in Logic Pro
Because the CS-32 MiniDesk pots are not motorized, Pickup mode is used if turned on
in Control Surfaces preferences. In Pickup mode, the controller must reach (pick up) the
current value before the value starts to change. This prevents sudden jumps of parameter
values caused by playing back automation.
A pot’s current value is indicated by the NULL arrow LEDs.
• The Upper arrow is lit if the pot’s value is above the current value.
• The Lower arrow is lit if the pot’s value is below the current value.
• Both arrow LEDs are lit when the pot has reached the current value.
The pots can operate in one of three modes, with one sub-mode in each.